How to Make a Beautiful Origami Bracelet!
How to Make a Beautiful Origami Bracelet!
Get the tutorial to create an amazing origami bracelet by following these simple, step-by-step directions! This bracelet will make a really special present!
It is suggested that you use either thick or thin card for this origami bracelet; there are plenty of options! Examples include (cleaned) potato chip packets, magazines, wrapping paper, music sheet paper, and a plethora of other items!
Instructions:
First, fold your strip of paper in half, from right to left, and then unfold it. Fold the right edge to the newly made central crease. Fold the left edge to the central crease.
Tip:
If you’re working with thick or card paper, you might want to leave a small gap in the middle to make things easier
Once folding is complete, begin inserting units.
Once again, fold the paper in half from right to left.
An even number of units—roughly 20 to 22—will be required. There is an alternation between the two hues. The first unit is the yellow one.
At the top should be the two loops. If necessary, you can open out the loops using a chopstick.
Take another unit and put the two loops of that unit within the first unit.
Keep Connecting Units
Set things up so they look as intended. Turn the two linked components around to face the opposite direction.
Separate the second (pink) unit’s two loops. Put the following unit in place. Proceed to perform the identical procedure on the remaining units. (Turning them around every time)
Turn the two linked components around to face the opposite direction. Separate the second (pink) unit’s two loops.
Put the following unit in place. Proceed to repeat the same procedure with the remaining units, turning them over after each one.
Connect the Two Ends
When you reach the final unit, remove it and unfold it. Refold it into the shape of an M. The colored side of the M should be facing outward.
complete the Bracelet
Snatch the bracelet’s other end. The two inner layers of an open loop should be positioned with the opening in the middle. Thread the two ends through the open loop together. Draw them through to the end.
Separate the two ends by folding them. Put the outer end into the bracelet’s inside and repeat the process.
Post Comment